- Vehicle Model
- 80 Series
1997 FZJ80 rolling chassis. Great candidate for 40/80 or 60/80 project.
Frame & axles have been gone over with wire brush & wheel and have 2x layers of POR15 (following instructions) applied.
They are locked axles w/rebuilt knuckles. Actuators work & engage. Has all the wiring and 4x4 computer + dash switch.
Slee 4” lift kit (springs, shocks, sway bar drops, radius arm brackets)
1FZFE w 305k miles - needs some attention and all fluids to be drained & freshened up, but ran before the truck was disassembled. Available trans & transfer case. Has wiring full wiring harness.
For everything: $4,500 obo
Just axles: $3,000 (wiring, computer, and switch)
Just 1Fzfe (everything including trans and transfer case, and harness): $1,000
Lift kit only comes with the rolling chassis - I’ll use it on my other 80 series if it doesn’t go as a package deal - I don’t have space to store axles and frames if it isn’t a roller anymore!
Was going to be a fun resto or body swap project, but I’m typing this holding a new 1 month old member of the family and I won’t have the time for a while unless someone had a 60 series shell they’re looking to pass on to someone.
Feel free to reach out with questions.
Frame & axles have been gone over with wire brush & wheel and have 2x layers of POR15 (following instructions) applied.
They are locked axles w/rebuilt knuckles. Actuators work & engage. Has all the wiring and 4x4 computer + dash switch.
Slee 4” lift kit (springs, shocks, sway bar drops, radius arm brackets)
1FZFE w 305k miles - needs some attention and all fluids to be drained & freshened up, but ran before the truck was disassembled. Available trans & transfer case. Has wiring full wiring harness.
For everything: $4,500 obo
Just axles: $3,000 (wiring, computer, and switch)
Just 1Fzfe (everything including trans and transfer case, and harness): $1,000
Lift kit only comes with the rolling chassis - I’ll use it on my other 80 series if it doesn’t go as a package deal - I don’t have space to store axles and frames if it isn’t a roller anymore!
Was going to be a fun resto or body swap project, but I’m typing this holding a new 1 month old member of the family and I won’t have the time for a while unless someone had a 60 series shell they’re looking to pass on to someone.
Feel free to reach out with questions.