This is still in one piece for the most part. I picked it up in a trade of sorts. I am interested in selling the whole rig less tires if someone wants it complete. I have some roller tires and wheels to put on it. The interior stinks(pet and smoke)but the seats arent too bad, rear is stained bad. Glass is good, most of the body is rotten. Has several good years of use left in -it is only a beater. 4WD works. Most everything electric works except one window switch is bad. Frame is structurally sound but isn't worth repair.
As for parts this is what I've figured for parting out for now.. Local preferred. Will hold if parts are paid for if dry storage isn't required. Not ready to mess with the little stuff. Keep in mind this is a very rusty rig from ILLINOIS.
Engine- 152 psi except #1 is at 123#- (valves need adjusting too, might be related) loaded except power steering pump. 55-60 lbs oil pressure at idle. $600OBO
Tranny/ Transfercase- $600 OBO no problems, drives fine.
Front axle (not parting out) complete $425 (torsion bar if wanted)
Rear axle less torsion bar $325
Please hold off on dibbing any parts not listed. I will leave all these parts attached to the vehicle until I have sufficient interest to make it worth cutting up and so perspective buyers can test if local. Would sell whole for $1400 OBO...
It is the same rig in this post
https://forum.ih8mud.com/60-series-wagons/206560-found-fj62-good-buy.html
I also will be moving slow on parting this out, so your patience is appreciated. Trade considered especially on an h55f, fiberglass 40 cap... what have you?
As for parts this is what I've figured for parting out for now.. Local preferred. Will hold if parts are paid for if dry storage isn't required. Not ready to mess with the little stuff. Keep in mind this is a very rusty rig from ILLINOIS.
Engine- 152 psi except #1 is at 123#- (valves need adjusting too, might be related) loaded except power steering pump. 55-60 lbs oil pressure at idle. $600OBO
Tranny/ Transfercase- $600 OBO no problems, drives fine.
Front axle (not parting out) complete $425 (torsion bar if wanted)
Rear axle less torsion bar $325
Please hold off on dibbing any parts not listed. I will leave all these parts attached to the vehicle until I have sufficient interest to make it worth cutting up and so perspective buyers can test if local. Would sell whole for $1400 OBO...
It is the same rig in this post
https://forum.ih8mud.com/60-series-wagons/206560-found-fj62-good-buy.html
I also will be moving slow on parting this out, so your patience is appreciated. Trade considered especially on an h55f, fiberglass 40 cap... what have you?
Last edited:
