1981 BJ41 Cruiser rear end!

[Otterav]

Location

United States

Hello,
Been sellin like a crack dealer! Here is the latest:
Rear axle from the 1981 BJ41 less the diff. You may ask why would I want this boat anchor? This axle has the parking brakes in the rear drum, no more trans case brake, this rear end comes out of a rusto Canadian cruiser so some of the smaller bits will have to be refurbed/replaced, but the big stuff is there, axles, backing plates drums, and whatever else you wanna pull from the truck before I cut it up. make me an offer(more than 20.00 though)
Ola
eric

 

[nmbuckaroo]

got any more parts from the bj41?

 

[Otterav]

Hello,
Some, what are you needin'
Ola
eric

 

[nmbuckaroo]

sending you a pm

 

[SabreTooth]

Frame available?

Otterav,

I just came across this thread and initial post. Please don't tell me you cut up the frame? I have a T-boned 01/82 BJ42 with a frame beyond reasonable repair (More $ than I a) paid for truck, b) I have available & c) than I'd be prepared to spend to straighten and then it'd still be rusty).

If the frame is still available, I'd be interested in discussing its disposal...

Please advise.

Thanks.

Regards,

 

[crushers]

Jim,
i know of a couple diesel frames in Ontario, i can go inspect them for serious rust or damage when i am down there...

 

[brownbear]

Otterav,

I just came across this thread and initial post. Please don't tell me you cut up the frame? I have a T-boned 01/82 BJ42 with a frame beyond reasonable repair (More $ than I a) paid for truck, b) I have available & c) than I'd be prepared to spend to straighten and then it'd still be rusty).

If the frame is still available, I'd be interested in discussing its disposal...

Please advise.

Thanks.



Regards,

Jim I'm pretty sure Gord(exmollad) in 100 mile house has a frame for ya. BJ frame.

He posts on here a bit, so you may want to ask him. He was going to let it go cheap.

 

[exmodlad]

Jim I'm pretty sure Gord(exmollad) in 100 mile house has a frame for ya. BJ frame.

He posts on here a bit, so you may want to ask him. He was going to let it go cheap.

Thanks for the hook Brownbear, but sorry the frame went to a new owner just last friday...

Best Regards

Gord

 

[SabreTooth]

Thanks for the responses, including PM from Otterav. I'll stop the thread hijack and post up a WANTED thread if I get no luck.

Regards