So In my 12/872 fj60 the front our put shaft on the transfer-case is leaking.
Not something I've ever done before, but i saw video on several other toyota 4x4 xfer cases of similar , and looked at the expoloded parts diagrams on SOR and Mega zip and it looks prety straight forward...if the Xfer case is on the bench.
(Video that looks pretty similar, For a mini truck, but the rear shaft, which is eaiser to get too...)
https://www.youtube.com/watch?v=a-_c7jKx7uc
(Fj40 video, does teh seal abotu 4 min in )
Are there any vids, walkthroughs, or Hints about doing it in the truck? That transmission crossmember sure looks like it's gonna be right in the way.
I have an FSM for up to 1980(that I bought for my 40), but no FSM for an 82, but I figure it's pretty close.
Thanks,
Eric/Cal-
Not something I've ever done before, but i saw video on several other toyota 4x4 xfer cases of similar , and looked at the expoloded parts diagrams on SOR and Mega zip and it looks prety straight forward...if the Xfer case is on the bench.
(Video that looks pretty similar, For a mini truck, but the rear shaft, which is eaiser to get too...)
https://www.youtube.com/watch?v=a-_c7jKx7uc
(Fj40 video, does teh seal abotu 4 min in )
Are there any vids, walkthroughs, or Hints about doing it in the truck? That transmission crossmember sure looks like it's gonna be right in the way.
I have an FSM for up to 1980(that I bought for my 40), but no FSM for an 82, but I figure it's pretty close.
Thanks,
Eric/Cal-
Last edited: