steering damper

Full set of front and rear Bilstein B6 4600 series shocks that are documented under 1,700 miles total - and were installed in February 2021 on a restoration FJ40. I have recently replaced these with the 5100 series and come as shown with bushings and no hardware. Will provide boxes if needed...

I can’t find this info anywhere and I’m not afraid to ask dumb questions, so here it goes: are steering damper bushings the same as shock bushings? My Cruiser came with an ironman steering damper and the bushing is shot.

I have a 1993 with death wobble that I've tried to fix and it's still not fully gone. I'm sure there are many things I could blindly try if I had infinite money, but how can I figure out which one is actually likely to fix the issue? I know this is a bit long, so to encourage responses: I'd be...

Hello everyone, I finally got around to replacing my steering damper from Dobinsons after a trip to Autozone and check out the ball joint separator tool. Everything was going smoothly until I got to the right side end of the old damper. I couldn’t get it out and I removed the bracket that is...

So I'm currently replacing my relay rod ends, and I'm running into a problem where the tapered bolt that the steering damper sits on is stuck in the bracket that's part of the driver's side (RHD) relay rod end. I have an OME steering damper, so the bolt is different than the stock one. Has...

Hi there, Have just finished changing tie rod ends on a 1991 PZJ77 and I've lost the nut that goes on the stud that links the steering damper to the relay rod. Can anyone confirm what the thread is on these? All I have to verify the thread is a metric tap&die set and it looks like it could be...

I currently have a Dobinsons (Australian brand) standard (non-RTC) steering damper. It's been on the vehicle for almost 8 yrs. Some time back a person said to get a RTC type damper (one of those ones with an external spring) but 'dial' the spring control back to zero. I don't fully understand...