greasing

Should I use my regular grease (Redline CV-2) or should I use a “Red-n-tacky” grease from Lucas or similar? I’m getting that “clunk” when accelerating from a stop. Thanks.

I was greasing the front drive shaft night and while I took the covering, I found these...seems like a lot of oil. I'm not exactly sure if it's oil or the fluid film that I sprayed last fall. For the 2014 LX 570, should I check the oil while it's hot, warm, or cold? I just changed the oil about...

I'm not sure what the factory spec is for servicing/greasing those components. The swivel hubs as we know are not a sealed space. Tail/prop shafts can be a pita if grease nipples on them and uni-joints are in an awkward position. I'm not sure about what the spec is for wheel bearing service...

I wanted to post on here and see if I can get any pointers. I believe it is my birfield joints that pop in 4 low at full lock left or right. Took the square bolt out of the top of the knuckle on both sides and started greasing. They clear up but eventually always start popping again. They do...