boots

Hey Ih8mud community. I recently purchased a ‘99 100 series in Texas. After driving it for a few days I realized both of my top CV boots on the front Axles are leaking. Took it to a shop and they tightened them down just for it to happen a few days later. The boots themselves are new and are not...

Hi all. Looking for advice on what to do about the CV Boots I saw leaking on my 2008 4Runner, 132k miles. See photos. Axle with the "CPTD" is passenger side and was replaced by dealership in 2019 when they said the original was leaking. The other/driver side (bottom photo) is original axle...

A packrat got into my resto-mod project and chewed holes in my transmission & t-case shifter boots. FYI, I am using an FJ60 bezel to give me room for the 4-speed under my 3-speed transmission tunnel. Please let know if you have a replacement set for me. Thanks!

Hi guys. I recently lifted my 02 lx470. The front sitting around 23 inches center to wheel arch. But I notice my boots look werid so I went down to 22 inches. And now it looks better but still werid. Should I keep driving or throw a new boots on for my mistake. And what height you guys sitting...

In preparation of installing Ironman suspension on my LC, I am doing a diff drop. The front ride height will only increase by 1.5 inches. I recognize that is not much, coupled with the diff drop, my boots “should” be fine. I am replacing the CVs with Toyota OEMs. As I want to try to plan for...

Refreshing your 60 Series Gasoline or DIESEL Alternator Connections Connectors Rubber Boots Ring Terminals Mounting Hardware 33+ Years Later and Why : i will go over my recent experience and what i discovered on GHOST's 3FE 5/89 - digging hardened then hard in JAPAN to find the original...

Have nice boots for the parking brake and transfer case shifter removed from a 96 80 series. Great shape, $35 for the PK boot and $35 for the transfer boot. Buyer pays shipping. Best to email me shmukter@pa.metrocast.net

What are some shifter boot ideas after modifying body/trans cover for small block chevy on a 1979 FJ40. Downey, back in the day and Advance recommends moving drivetrain forward for correct engine placement. This puts the shifter boots at the bend between firewall and trans cover, under the...

Since lifting my 2007 FJ last year my inner boots started leaking. I did a quick fix last summer with some grease and new clamps. Just recently I noticed the boots have now blown out. It was recent but I'm just not sure when it happened. Not noticing any squeaking or clicking. Considering...

Hello all, Opening this up to the forum. I have another torn CV boot. Second one this year. Do I need to keep these on hand after each trip out to the mountains? Curious if there is a better, stronger boot out there that might last a little bit longer after being hit by rocks on shelf...

Welp, here I am down the rabbit hole looking to import a troopy from Australia. I'm looking for an individual who can act at my 'boots on the ground'. -Vehicle inspection -Purhcase -Transport to port If anyone has any recommendation I'm all ears! Thank you!

Today I took my reman axles and rebooted them due to my lift. I've done both the inner and outer sides and now I'm concerned I did not do the outer correctly. I placed the outer boot in the exact same spot as the original, but the wide opening section that goes over the outer joint casing is...