Recently did a timing belt on my wife's 2006 4Runner (2UZ) and it is the AWD Sport Edition which came factory with the A750F 5 Spd. I had heard somewhere that there was a way to adjust the line pressure or the firmness of the shifts without any modification whatsoever. I made a point to adjust...
Around 200k miles on my GX470 and for a year or so Ive been having a delayed shift from R and N into D. I replaced the drive shaft and it seemed to help a little, but the delay was still there from time to time. (I also flushed the trans fluid and replaced the filter about a year ago but the...
Merry Christmas all,
I am new to the forum community. I will say I have been relying on the forums for many questions or issues I have run into but, I believe I have an issue that I haven’t seen on here.
With that said I am in need of a transmission and wanted to reach out to see if anyone...
How many clicks does the converter click in to seat? Mine has seated 3 clicks but doesn't want to mate up to the block like it should, does the converter seat 4 clicks?
I have a used A750F 5 speed auto transmission that came out of a Toyota Sequoia 4x4. The transmission has no issues, shifted smoothly, and is ready to be used as is or would be a great unit to rebuild. The transmission has 177k miles on it. The 03-07 100 series Land Cruisers also use the A750F...
Hi
Is there a difference between the diesel and petrol A750s like there is between the earlier transmissions?
My understanding is that there are usually more plates in the clutch packs in the higher gears in diesel version, however i cant seem to find any information related to this on the A750...
AT OIL TEMP ISSUE: LX470
I just purchased a very clean 2005 LX470 from the Lexus dealer in Henderson NV. 105k miles, 1 owner, seems to drive great. I was very excited …. However, there’s an ongoing issue with the AT oil temp.
Backstory:
I flew to Vegas to purchase. On my first attempt to...
Hi guys
I have 2003 landcruiser amazon with a750f auto transmission
I have replaced the transmission with h151f manual transmission
I need four step ecu for this setup
Any help plz
Build as of June '22:
-60 body and frame
-80 full float rear axle, 80 rear discs, Detroit locker, 4.88s
-Rear springs = 5 leaf Chevy 63s with overloads, frenched shackle hangers
-Rear shocks = 10" short body remote reservoir Bilstein 7100s w/ 400 valving
-Cut and turned 60 front axle housing...
Hey guys,
Anybody heard of a place that modifies ECU's for the 2UZ-FE engine that strips it down to the basic essential engine functions? I'm hoping for an ECU stripped of the immobilizer, emissions, and other uneccessary functions.
Any leads?
Thanks!
-Kyle
Hey guys,
Anyone have a wiring diagram laying around from a 2UZ-FE swap? I'm trying to figure out how to go about stripping my harness of all the unnecessary wires.
Thanks!
Kyle