Search results for query: *

Forum search Google search

  1. lumberjack

    highest mileage cruisers out there (original engines)

    1991 FJ80 288,000 Miles No major engine repairs just new water pump, radiator, alternator, and valve cover gasket. I need to replace rear main oil seal but that has been leaking for the last 5 years. Not loosing enough oil to make me change it yet. I figure it is just acting as undercoating...
  2. lumberjack

    Question 2006 V6 Tacoma motor

    OK, guys what are your thoughts on putting a V6 4.0 liter Tacoma motor in an fj80. I may have a chance to pick up a whole truck for cheap and would like a new motor in my 80 anyway. I am sure that it most likely has more power than my 3fe, but is it worth the hassle. I would like a little of...
  3. lumberjack

    A1 Cardone Window Motor (has anybody used one)

    Has anyone used a A1 Cardone Window Motor, if so how was it. Its really cheap comparied to a SOR or toyota window motor. thanks
  4. lumberjack

    1991 fj80 transmission fluid

    someone was saying on another post that valvoline will thicken up at colder temps. Not sure if that really makes a bid difference or not. Thanks everyone for the quick replies
  5. lumberjack

    1991 fj80 transmission fluid

    Ok after reading about past transmission posts for the last two hours. I wanted to make sure that I could do this. I have a 1991 fj80 with what I assume to be a A440F trans. with 240K on it. It calls for dextron II fluid in the truck manual, but would it be beter to run Mobil 1 synthetic oil...
  6. lumberjack

    How to measure suspension lift

    What is the best place to measure an Fj80 to find out how much lift it has and what is the stock measurement for a 1991 Fj80. Thanks
  7. lumberjack

    AC compressor

    How hard is it to rebuild an AC compressor in an fj80. Mine leeks and I see you can buy kits for $50 from spector. I am very mechanical but I have never messed with AC units before. Any help would be great.
  8. lumberjack

    Tired of the auto antenna...who's gone with a flexable rubber stubby antenna?

    I broke my factory antenna on the trail and finally got annoyed with it when I was sitting at an airport waiting on my best man that was delayed 6 hours. It was a two hour drive to the airport and another 5 hours to the wedding. So I could not go home to pass the time and decided to drive to...
  9. lumberjack

    Wondering steering

    I am running Bridgestone Duller A/Ts on this truck and I think I run them at about 35 most of the time. I do try and rotate them on a constant basis. This truck does have 220000 miles on it but I did rebuild the whole front end about 2 years ago and the truck drove well till now. You are all...
  10. lumberjack

    Wondering steering

    Well, I purchased this truck with the lift and the 33 on it. I am not sure if the caster was corrected or not but the truck drove fine since I bought it 2 years ago. This has just become a problem in the last 6 month. I had not done anything to it before this started to happen. I have...
  11. lumberjack

    Wondering steering

    My 1991 fj80 is starting to fallow groves in the road and the steering is getting sloppy. I know I need new sway bar pushing but I don't think that would be causing all of this. I looked at my tie rod ends today and they seem all good. (No slop in them). If anybody has sum suggestions as...
  12. lumberjack

    LT1 engine conversion

    hello Thanks everyone for the info again. Well that is what I figured on the power begining sooner in the power band with this engine. See now I have the 3F-E (NO POWER ???) from what I have read only about 155ps so this is why I need a V8. Everyone that I have ever talked to about the 3F-E...
  13. lumberjack

    LT1 engine conversion

    Well thanks for all the info so far everyone, every bit of information helps. My biggest problem is that I have the fuel injection LT-1 I was told it came out of a 1994 corvette or camero. I have the computer and the wiring harness that was used with it. I am worried about what the best way is...
  14. lumberjack

    LT1 engine conversion

    Hello All I was wondering if anyone has ever swapped an LT1 engine into an fj80 or more specifically a 1994 LT1. I have the opportunity to purchase an LT1 for a great price :D and have wanted to put a V8 in my 1991 fj80 for quite some time. If anyone has any information on this conversion or...
  15. lumberjack

    Radiator Dilemma fj80

    For those of you that have done the V8 conversion on an 80 series, I was wondering if any of you had to change the radiator or if the stock one is good enough for the V8. My current radiator has a crack in it :doh: and I am looking for a new one. I have the 3FE motor right now but I am looking...
Back
Top Bottom