I watched a few Youtube videos. The first one by Azcruiser ( ℹ️ How to: Install Adjustable Panhard bars (80 Series Toyota Land Cruiser) ) I couldn't understand if he was lifting it or not, or what he was saying about alignment if left the wheels on the floor...
I need to replace bushings on front panhard. Thanks to great recs on this forum I have two new Toyota bushings on the way. I don't have a hydraulic press though. I want to take off my front panhard bar and take it and the new bushings to a shop. Where should I take it?
Various Pics:
https://drive.google.com/drive/folders/1EvY6ie3L7MBL2GSckGGQbCIOQNN_n-aX?usp=sharing
Specifically, I think it's this bushing(?) bushing
What is this called?
Where can I buy one?
Can I fix it myself with mechanics tools, or does this require a hydraulic press?
Thanks in advance!
After reviewing previous threads re: "my intake air tube has holes, do I need to by the OEM replacement or can I buy the cheap ebay replacement," which concluded "you need to buy the OEM," I decided to try FiberFix repair tape. Not even the automotive version, which is supposedly more...
http://ebay.us/5e95pf?cmpnId=5338273189
Also listed on ebay. BIN $175. Photos there. Non-cracked. All tabs in tact - one tab has a tear but not consequential.
My GF uses the LC as her daily driver. The front brakes need replaced, and it's had a whine from the front diff since I bought it. There's a guy in Chandler that is a specialist in 80-series gears. I've changed replaced discs & pad on a handful of different vehicles, but when I did a search for...
Now, after putting gas in the tank, it sounds like it is misfiring on one cylinder. Is there any reason these things might be related? We've only driven it a few times .25 mi to the store and back since then. Kind of afraid to drive it farther.
Thanks
Just finished replacing the head gasket. It just won't start.
Here is what I have tried so far, and the results:
-Re-did the procedure for installing the distributor.
-Took off distributor cap, set crank to top dead center, and verified distributor rotor is pointing in correct orientation...
Trying to put everything back together after a head gasket replacement. The wiring harness and all the emissions stuff are giving us fits. #1 right now is this very large female plug. We can't seem to find its male counterpart anywhere under the hood. Does anyone know? Thanks very much if you...
Imgur: The most awesome images on the Internet
We got the head on today and got stuck staring at the motor trying to figure out what wire goes where here as the sun went down. Judging by the diagram, this appears to be the driver's side, back of the motor, and the wire appears to be a ground...
Head gasket blew. 286k miles. In my other thread you can see that the block surface is rough. I know to be on the safe side I should have the block surface milled too. I was thinking about renting a truck and a cherry picker to pull the engine, but I'm not sure what steps are needed to do so. Is...
I am trying to remove the camshafts. At this step, the FSM says "[p]lace the matchmarks on the camshaft timing gear and timing chain." See attachment. I don't see any marks. Is this saying that I need to scratch the gear and the chain to make a mark?