Search results for query: *

  • Users: KFJ45
  • Content: Threads
  • Order by date

Forum search Google search

  1. KFJ45

    Brake Cylinder Question?

    After a long delay, the resto has resumed on my 1978 Aussie RHD FJ-45. Updated build thread to follow. Problem/question. Purchased 8 new wheels cylinders and installed in their correct positions. All boxes were clearly marked. Then I realized the Rear axle/left rear position only had one side...
  2. KFJ45

    SOLD  FJ45 Steel Cap with Boat Rollers...New Jersey Shore

    Afternoon All. As I re-ignite my 45 Frame-Off resto project, I've decided to let this original piece of the rig go as I'll have no practical use for it. Because it is well made, I thought some of you would get much better use out of it on the backroads. The Story: I purchased my 1978 Aussie Spec...
  3. KFJ45

    Slip Yoke/Dust Cover Felt Seal

    Afternoon gang. The 45 resto continues and after several searches I've found very little info on those pesky felt seals in the slip yokes dust covers. Only solution I saw was a thread where a rubber boot was placed over the driveshaft. Functional but not what I'm looking to do. Any...
  4. KFJ45

    Zinc Plating Brake Lines

    Afternoon, looking for opinions on this. Took in all the hardware and had it Zinc Plated. I also took in the Brake Lines, figuring what the hell. Like all the hardware I soaked them in EvapoRust (amazing stuff). I know, they tend to rust from the inside out. My rig came from a dry climate and...
  5. KFJ45

    Dented Pulley

    Was painting a couple of parts today and Bang, the pulley drops off the hook and hits the concrete (about 18 inches) I know, I know WTF!! Opinions??
  6. KFJ45

    Over Ambitious Powder Coater

    I think I know the answer to the following but I’ll toss it out there for s***s & giggles. My Powder Coater got a little ambitious and also did the inside of the knuckles. I’m thinking it’s best to have them blasted out to bare metal. Thoughts...???
Back
Top Bottom