Hello all,
Can anyone that is running a Weber 38 recommend a guide on proper jetting?
Or suggest a jetting that works for them?
I need to get a good baseline, or least go back to what was stock (which I don't know how these shipped originally).
Most time spent at 2100 feet with my occasional...
Hi all,
Looking for recommendations for someone who can rebuild my carb.
I’m aware that Jim @FJ40Jim is the goto guru. But I haven’t been able to contact him and don’t know if he is still doing this.
thanks!
Ok,ok, I know the answers will be throw away the Weber and go back to stock. Which I might but not so easily reversible.
But hoping for some help from those of you who have chosen to endure with a Weber carb.
I’ve got a new Weber 38 DGAS on the 60.
Starts, idles, run beautifully. Will idle...
I read in an old post that quite a few members cured a stumbling/hesitation issue by simply disconnecting the tach at the coil.
I have a question for those who know about this fix.
The tach disconnect only works with those running stock ( Asian) carb, correct?
It is somehow effecting fuel cutoff...
Hello all,
I’ve got a 2F with Weber carb and non-us distributor.
please no hate on the Weber , I know, I know, It‘s what I got and have to live with for now
was running pretty good last time I drove (month ago)
Today started up and running great. Until I got a few blocks from home. Started...
Trying to install brand new non-us Toyota distributor in 2f engine.
Well, it isn’t going in all the way. It is bottoming out about 1/8” before the mounting bracket hits block.
Through several hours of trying this and that, comparing new to original, measuring, marking, etc I’ve concluded the...
Just swapped to a Weber carb.
In the process of adjusting it I looked at my shop floor.
There is a huge puddle of oil. Oil seeping out of oil pan, side cover, and valve cover.
I unscrew the fill cap and the pressure blows it off.
Any thoughts on why an engine that wasn’t doing this when shut...
looking for used working fuel tank sending unit for FJ 60 or 62
Or suggestions for an alternative to OEM or source for one that isn't gold plated. ;)
Thanks!
Hello,
Looks like I need to source a tail light lens off of eBay.
Anyone here purchased these $20-$30 lenses?
Can you speak to quality and closeness of color to original?
Should I just get both sides if I only need one to make sure co,or matches?
Thanks
Just finished desmogging.
However, my cruiser was missing the vacuum switch all together.
Unless ther is an alternative location on some?
So I plugged the port on the carburetor and finished the desmog.
So my question is.
Do I need to get one and install or can I get by without it?
Thanks
Just got my second 60 after selling my first one years ago!
I’m getting really bad surging while at lower speeds and it is better at faster speeds. I suspect the higher RPMs or just momentum smooths it out but you can still feel it.
The surging goes away during WOT.
I was going to just...
So the cruiser has been occasionally hard to start but running great otherwise. This occasional had turned into frequent int now it won't start. Just cranks no firing at all.
Made an appointment to tow to the local dealer on Monday as I didn't have time to look at. But the thought of that...
Trying to troubleshoot my rear latch lock actuator. I have taken apart cleaned and regreased with silicone grease. The motor spins but very weak.
Got the multimeter out to check power to the motor. Not sure what to expect. Can someone fill me in as to what I should be reading off of the...