In the process of reinstalling my rear axles after differential work and I seem to have an issue. When I slide the axles in the mating surface isn’t flush, there’s about a 5 mm gap that feels sort of squishy. I can tighten nuts and remove the gap but it doesn’t "feel" right to me. Any comments...
Calling any Harrop / Eaton ELocker 100 Series owners with the newer style NGR switch that is supplied with the wiring harness!!
I'm finding out that this Eaton NGR switch in the pic below may need a bigger cutout than your more "standard" Carlin (sp?) styles. Does anyone have any...
In the middle of repairing this:
And then I found this:
I have the transfer case out as well to regear low. Was getting ready to work on rear of vehicle, jacking it up and I got a jack in the front stuck under the lower control arm. I had left the AHC in High on purpose and I believe the...
GONE THANKS FOR LOOKING - $ + Shipping Cost
Well worn but not too abused. They are a bit darker than in the photos. I hate throwing things like this away but they are somewhat awkward to keep moving around to different spots in the garage.
I have a nice sturdy box to roll them up into...
Can anyone who owns a Gamiviti rack with the wind deflector installed give me some feedback here? My wind deflector has developed a rattle. If I open the sunroof and grab a hold of it the rattle goes away. I believe this goes back to my install when I couldn't figure out how to use the center...
I've been researching sliders this past week and would like to get some new information from the 100 community.
Pop out sliders or not? I've settled on tube sliders not steps. There are a few references to reasons for pop out vs. not but I couldn't find a thread for it plus with more time...
Hello fellow Mudders.
I've had my heart set on a 100 since Aug '16 and have been searching that entire time. I drove 7-8 different candidates, went to physically look at a dozen and missed on 1 or 2 by waffling and/or trying to negotiate. Well, I finally found and purchased my new to me 100...
Edit: Not mine!! $35k!!
2003 with only 40k, straight up Unicorn no? No real service history, originally from WV. Amazing.
2003 Toyota Land Cruiser, Stock No: SIMON-16766 by Auto Connections of Bellevue, Bellevue WA
rjones
Super low miles. Pretty clean looking.
Other odd tell-tale signs IMO:
looks redone front seats, seems odd for that mileage
zooming in on some interior areas looks higher mileage worn
bent running board, maybe beaten up off-road?
lastly, pinged the number and he didn't want to give up the...
Hello,
New to the forum after lurking around for a month or so. Did a quick search and didn't really find a discussion related to my question so I apologize up front if it's redundant.
Is the factory rear locker "good"?
I've settled on an LC100 and have been shopping around a bit and have...