Looking for front proportioning valve 1985 60 series not lspv. Also if you have the brake lines that I could use as a pattern to make new lines. Thanks
Going to ask here, got a Con ferr roof rack for my BJ lost one gutter clamp (part with stud) anyone have one lying around? Have to replace some of the studs so even a broken one would help. Thanks everyone
Just bought a Con Ferr roof rack it is missng one of the holddown the one with stud. Anyone have a lose one around I have to replace a couple of studs so one with a bad stud is Ok. Thanks Bill
Is there a way to use 38mm gears in a 34mm manual shift case? Can it be done using the intermediate shaft (34mm ends with 38mm center) that is used in the kit to put the low ratio gears set into 34mm case? Thanks Bill
Is there a simple way to use US 1000 series pto joints with a Toyota pto unit? Is there a flange yoke that will bolt on pto output flange yoke? Is there a conversion ujoint to go from Toyota flange yoke to 1000 series yoke. Thanks for any help.
86" BJ60 full floater rear axle doesn't have brackets to mount sway bar. Can someone supply drawings and or photos with dimensions? Is there a weld-on bracket available or does someone have a set that was cut off and axle. Thanks
I have a 86' BJ60 from Nicaragua it doesn't have a tach, I would like to install one. As near as I can tell my bellhousing is not drilled and tapped for sender. What I need to know is do I have to get a different bellhousing or could I drill and tap it? Also does the flywheel need to be changed...
Posted on 60 tech and tire tech not getting much help except put 235 radials on. My BJ was imported from South America came in with 7.50-16 on split rims, somewhere the tires got changed. I am trying to go with the OEM setup I can find street tread or Super Traxtion tires with no trouble
, but...