I have a brand new Cruiser Teq Rebuild kit with the Koyo Bearings, the whole kit is made in Japan with the bearings. Brand new in box. 150$ plus you pay shipping. Only opened to take a picture. I threw in some other new gaskets I had for the hubs. I will take PayPal GS if you pay the 3%.
I have a chrome less windshield gasket from City Racer. Ill sell for 70$ plus you pay shipping. It does not have the cut out for the chrome inserts bc I was reading how much of a pain in the A55 it is to save the chrome so I opted for the chrome less gasket.
I have a FJ60 OEM Carb, it is rough looking and will need a full rebuild. It was from a 1986. 50$ plus you pay shipping. Ill do whatever payment method you want, but you pay the extra fee for G&S
I have brand new Trail Tailor C channel reinforcement kit for a FJ60, never installed. I will sell for 220$ and you pay shipping. I'll do PayPal goods and services if you add the 3% or Venmo, Apple Pay, Zelle. I will get some pictures asap
Toyota dealership replaced fuel tank on my 86 fj60. The truck wasn’t running and they gave me an excuse they couldn’t open the fuel door.. so they never tested anything.
I got the truck running and have been using a 1 gallon fuel tank. I blew out the hard lines, hooked up a new fuel filter and...
Project FJ60 would start and run.
I was bending brake line by front axle and a loose ground on frame touched the positive wire going to the starter. Now I have no power to the dash and battery is at 12.9V
First thought is fusible link, but I can’t seem to find one. I’ve checked all fuses on...
I was following a thread called heater core flush for dummies that is a good write up but the pictures are no longer available and kind of confusing. Can someone post pictures of which hoses I could flush my heater core with? Thank you
I purchased this Cruiser as a project and it wasn’t running, so I am trying to piece it together. I put a city racer carb on and re assembled the throttle linkage.
The gas pedal basically sits on the floor and when I push the pedal it barely moves the linkage on the carb. I am pretty sure I...
I am trying to revive my 86. I finally got it to a point where I can start the engine, so I went to try and flush the cooling system. Here’s the problem, I put 4 gallons of distilled water and a coolant flush bottle. Ran the engine for a few minutes ( high rpm’s maybe 1500 bc I am trying to tune...
I am trying to revive my 86. I finally got it to a point where I can start the engine, so I went to try and flush the cooling system. Here’s the problem, I put 4 gallons of distilled water and a coolant flush bottle. Ran the engine for a few minutes ( high rpm’s maybe 1500 bc I am trying to tune...