Pr86yota

Thank you, I switched them around and it’s not hitting the carb plate or catching anywhere that I noticed. (Although I haven’t taken it for a spin yet- got the truck running.. now it won’t go into gear. Hoping that’s just something going on in...

@2mbb @DFXR i thought I’d post a reply. I ended up switching the horizontal linkage around from the firewall to the carb and that fixed it!

@OSS Thank you, if I go that route instead of a fusible link- what wire do I splice it into? There is one wire from the battery spliced into 3

Add a 40 amp fuse between the wiring harness and the battery. It will be your new fusible link. It’ll prevent the whole harness from melting down or a fire starting if a short occurs before the fuse block.

That That fixed it, just had to remove battery wires and reattach them. Easiest fix yet

I'd start by reattaching the loose ground terminal to the engine block, and cleaning the battery terminals and the battery posts. Take the wire out of the positive battery terminal and clean that as well, as for your fuisble links (according to...

Project FJ60 would start and run. I was bending brake line by front axle and a loose ground on frame touched the positive wire going to the starter. Now I have no power to the dash and battery is at 12.9V First thought is fusible link, but I...

Link to thread?

https://forum.ih8mud.com/threads/heater-core-flush-for-dummies.209078/

I was following a thread called heater core flush for dummies that is a good write up but the pictures are no longer available and kind of confusing. Can someone post pictures of which hoses I could flush my heater core with? Thank you

my vertical linkage is 205mm ball center line to ball center line. Also, the horizontal rod should be installed as shown with the longer rod (red) at the carburetor and the shorter rod (green) at the firewall. If you disconnect the vertical...

@2mbb @DFXR I rechecked the linkage and the spring is closed and the throttle is not wide open- but the pedal is still close to the floor and the linkage circled in red occasionally gets stuck on the bracket. I am starting to think maybe my...