Recent content by SilentUnicorn

  1. SilentUnicorn

    Exploding sound inside the cab when I start the 60 (sometimes)

    why is there an explosive mixture under the cap?
  2. SilentUnicorn

    Incase anyone is looking to bid on this...

    kinda strange indeed, My 2f has 280k+ did a comp check and it is dead even at 150# on all 6 holes, guess that was rebuilt too.....
  3. SilentUnicorn

    Please, Mechanic Charging a lot!!

    oops guess i was wrong. My apologizes.
  4. SilentUnicorn

    Please, Mechanic Charging a lot!!

    actually Birfield DOES have a 2f manual http://www.birfield.com/modules.php?name=Content&pa=showpage&pid=77 but beware the hi resolution is rather large.
  5. SilentUnicorn

    What's the right repair manual for 88 FJ62?

    Nice link if it would work. getting 404 errors on the d/l page. i even registered.
  6. SilentUnicorn

    Desmog +Cam

    i take it this was too stupid a question to even warrant an answer?
  7. SilentUnicorn

    Desmog +Cam

    I have done some looking around in the archives. i have not seen this question. regarding the 2f are all stock cams the same irregardless of smog equipment? i know that on some vehicles the detuned the cam to help meet emmision standards. And this can lead to poor performance after...
  8. SilentUnicorn

    Intro

    Thanks for all the replies! VTCruiser, ayup near Rutland, actually east Wallingford, not to far that s for sure. The way i see it is a block heater isnt a bad idea, but it sortof just treats a sympton, not the illness. i did notice that my choke is not closing 100% of the way. it could maybe...
  9. SilentUnicorn

    Intro

    Hello All, I just joined after lurking for several days. Found some good info here using the search. My name is Mark, i live in central western Vt, I tend to prefer these older rigs over the newer stuff. I find they are built better and are easier to work on. My last revival was my 75 midget...
  10. SilentUnicorn

    2F Engine Removal--I don't get it

    Hello Folks, i also may be looking at the same engine yank as mrsvle. My question is why is it advisable to separate the engine behind the bell housing? And anyone got an idea of what the 2f weighs? I have just joined after lurking about here for a couple of days and searching for various...
Back
Top Bottom