Recent content by Scott.t

Hey guys just a lurker here for the most part but have been troubled with high egt and lack of power on hills. I recently was in to see Dan and picked up a power rod, the install was easy and fast. Performance change well yes. but only above 2600 rpm, the down side was a huge loss of performance...

Hi i,m looking for one Berg Alloy wheel. size 16x8 J with a -13 offset. These are common on the JDM 80 series being imported to north america.If you have one or more to sell please email me @ mobydog@hotmail.com See attached pic for reference. Thanks. Scotty

Hey i did all my bushings and have a 12 ton press in my garage in edmonton. You can have it for 125 cdn. if you want it call me @ 780-233-4468. Scott

I,d recomend getting an aftermarket sender and gauge. they are easy to install and alot more accurate then those factory ones. I went with a Koso digital gauge kit. only trouble i had putting mine in was finding a short adapter to go from metric npt to us npt for the sender.

Ok i looked into ups seem to save a few bucks shipping from vancouver. I will take it with me and ship it out from there. Please email me at mobydog @ hotmail.com and i will send you some detailed photos of the bumper. and we can discuss price. I would like to send you the pics as there are...

Hey your right Grey hound will ship that I will check about rates tommorow. Once again thanks for the tip. And I will be in Vancouver thursday and friday this week if you wanted me to drop the bumper off some where there.But i would need to know before i leave on wednesday morning. But i will...

Well i looked into shipping and it doesn,t look good Both canada post and puolator said it was too big. Do you have any suggestions? or have friend or family on the canadain side of the border near vancouver where i could drop it off.?

I will find out for you. I am actually headed to vancouver bc later in the week and could ship it from there it is alot closer might save a few bucks i will let you know what i find out. And yes i have the frame end brackets with tow loops and the littlle end brackets that hold the bumper to the...

Thanks for the prompt payment. Shipped it out today. So who wants the bumper now?

Yes that was a factory light bar. I am sure there will be more becoming availible as alot of hdj81 cruisers are arriving in canada and quickly being modified. with winch bumpers. Cheers.

Ok i have been convinced to sell the lightbar seperatly and that is sold so i have a great stock bumper left and will part it out. please email me @ mobydog@hotmail.com if you want pieces of it.

Ok here goes . Thanks for the tip

Cheers to that Replacing the stock bearings with the Acl bearings seems to end the conversation on BEB failure.

I haven,t gone into great details with it but i calculate that i get about 10L/100km at 100kph and goes down to about 12L/ 100k At 110kph. But When you drive a vehicle that holds 245L you tend not to get to concerned about a wee drop in mileage. Cheers

hi My cruise works fine but remember if your truck is jdm you can only engage the cruise at speeds below 110 kph. not sure what speed you are trying to engage it. hope this may help.