Recent content by Ruffy

Dunno what they are called over there. But Honda Accord seats fit almost directly onto 60 series rails. From memory all you need is to drill the bolts holes out to 10mm or maybe elongate them a touch. honda seats are real nice. I think it was from about 1988 to 1995. something like that. Cheers, Dan

Thanks Guys, I am a little confused with the H55, H55f thing. What are the differences and which one do i need? Are there different splined and length input shafts on the same G/box codes??? Pic of supercharger..

The engine i have was free. It has injectors, pump, waterpump, etc. need manifolds and electrics. There easily come by. The bull bar i made. The winch looks closer to the radiator in the pic. There is actually 4 inches clearance between the winch housing and the radiator. And before anyone...

Hmmm. I thought someone might know something!

Just be careful when reinstalling the nut. They do not need a great deal of tension. Usually a nylock nut is used. The shafts are not generally hardened and break if too much tension is applied to the nut.. Cheers

Hey, I have 4.88's with 36's and it's good. Around town i run 33's just so i don't wear out exxy tyres. It's sucks bad on the highway. 100km/h or a touch over 60mp/h is enough for the ears.. and fuel economy. I would definitely advise against 4.88's and 33's for highway use. If it was a crawler...

The "New" truck.

Current truck..

Hey guys, It's been awhile but i found my way back here.:) I am looking at putting a 1HZ into my Hj60. I have searched and found heaps of useful info thanks everybody!. However there are question aplenty that i could not find covered. Firstly, as silly as it may seem, Can i bolt the 1HZ up to...

OK. so it's too hard. I kept getting told that i couldn't do it. So now i know the cross member doesn't bolt to the chassis. Thanks!

I'm twin locked with 4.88s on swamper Q78's and the difference is awsome. If you go over 35, then go 4.88's. 35's suit 4.56.

I run Q78 swampers on a hj60 with 2 inch spring lift and 2 inch body lift and 50 mm extended rear shackles and 25 mm front. Q78's are almost 36x11.50 and the rub every where!!!!! They're on 25 mm offset rims. They hit the springs on lock. The front inner of the the front wheel arch on flex. The...

Cheers guys, so if i want to do tihs i use my existing bell housing and grind it to suit the 5 spd, correct? So does this mean that i can't use the 5spd bell housing? Thanks again.

short of spending another 5 hours searching i figure it will be easier just to ask... I have an early HJ60 4spd. I have been told that the later 5spd will not bolt up??? Is this true? I am well aware of the Driveshaft length issues and crossmember/g/box mount issues, that's not the problem. I...

I was just thinking the same thing??? has anyone else put any fuel in it??? it may be fouling plugs because of the wrong fuel.