MOTOV8R's latest activity

The 3.3:1 set is a bit smaller. less machining of the case. I am not sure I need the 10% underdrive in high range, but will take it. If I think about it, I will measure the old and the new gears.

Case is sanded and ground out, test fitted with all bearings in place and no grinding. I pulled the rear case cover off and found a small hole in the top area. A little jb weld and I will let it set up overnight. It should not be a problem...

That gear is yuge!

👨‍🏭

I have also been distracted with an addition I have going on my garage. Buddy left his dump trailer here so I could clean up a little.

Speedo(GPS) shot- on 33s and 410s.

I never got around to the t case gears for the CO trip but may need them here on the east coast and other places. Sumo 4:1 gears going in. My buddy got a machined case from CB and was nice enough to let me look at it. I measured it and will...

My eyes love it, but my wallet is crying :frown:

Best price I could find was Amazon 1 month ago, $224 a piece. Prime free shipping

...this just in, CAD shows it at 44.5 Gallons.

Thank you, I think that is what I needed.

I went through this with my 40. Here’s my write up Post in thread '‘73 FJ40 followed me home. Now updated! 2/11/25' ‘73 FJ40 followed me home. Now updated! 2/11/25 -...

Got the roof rail re-riveted and sealed...

It has way too many issues, RF fender is bondo thats chipping out, got all those holes from the snaps on the Bestop got several random holes drilled...besides, I done got a survivor....

This needs a save-the-original pant restoration 100%

We will be updating pricing and have been pusruing production on a scalable basis since 2018... Costs have been high with low volume numbers but we are aiming to get that down as you can bet Tier 1 Automotive manufacturers just are not in the...

Almost done!

The 60 engine is the way to go. Better ignition, hp and oiling. Swap your 40 bellhousing/tranny and transfer onto the later 2F and drop it into the truck. Youll be able to run your existing carb/intake and exhaust if its in decent shape and...

Friend found this in a Culdesac in McKinney thaw house had a 2 car garage with a one car attached. He had never seen the one car opened in ten plus years. One day he noticed it up, and spotted the front end of an FJ40. It took a couple of years...

Whatever husband says otherwise is either lying or soon to be ex.

Flip kits for both axles Dave added the partial pipe for get the center of the rim on to make it easer to line up the studs at no charge. I am 67 now and 217 lbs at 6-3 but my strength is different then when I was 210 at 34. I got the 5...

4Plus tire carrier is probably the upgrade that has made the most difference in my 40. Incredible build quality and easy install.

here we go. Just did the one for now as today was a lot busier than i thought it would be. so this is set up to be cut from a 2.4x1.2m sheet of steel, not sure what US standard sizes are. But thats about 4 feet high. as cut, you will get an...

The leafs wrap partially around the main leaf, so that is supporting the main leaf completely. The spring eyes are much larger than stock which will help the bushings last longer than the far too small stock bushings and make for a more stable...

This kit really looks great. I was very close to picking one up earlier this month I changed some things on my 40 and used some springs I had. It rides much better now, not sure it is as good as these would, but I like the ways these look...