miller's latest activity

He dropped it yesterday with a nice list of upgrades and service items I spent the day yesterday pulling a 3.70 out of a 60 axle I bought for this purpose a few months ago. Drums were hopelessly frozen so I had to cut the drums off. Not fun...

I did not.

Doing almost real truck things with it today.

Steelies from an 84 4runner. Need to install hub cap clips if I decide to spend the money for acorn caps.

A friend made these for me. Top one should work. A high quality outdoor vinyl.

Damn I tried to get back to the rig!

Funny!

I just want to know when the diamond plate is coming off!

Pm sent.

Box final welded, ready for the once over and off to the body guy for blasting and primer. Tailgate, rear sill and hooks courtesy of @Awl_TEQ :cool:.

Welded the wheel arches to the sides. I decided to weld both edges to the side and then cut out around the bottom in the hopes that it would stay straighter. I tried to go slowly building on tacks as I went and cooling with air, but even so...

Pm sent for wiper motor.

A liitle more choke at cold startup today and she cranked right over, ran great with several hot starts over the 3-hour tour of the upland ground we just pushed 150 cow/calf pairs (and 4 bulls) onto, 400-lbs of mineral salt blocks and several fly...

This is a repair- not a restoration!! On our last adventure, The 8274 gave up the ghost. It was a hard pull and I don’t fault at all. More than likely it was my own fault- I had run out of the heavy gauge wire to feed the motor, and I used a...

I need one also.