Recent content by Maynster

What size 8 switch Auxbeam is being used? Looks like there are two different ones?

I’d like to purchase one of these if they’re still available? I’ve a PM for you. Thank you for your time.

No kidding.

Fixed! I thought I got all the trailer wire stuff out, until I removed my drawer system and found that pinche box Toyota used for trailer wiring. Yeah, removed and everything is working as designed again.

No. There isn’t a trailer harness there.

only one set. I did the marker light turn signal mod noted on Slee’s website. Not marker lights for sure it’s the turn signal lights, all of left ones, front and back. I spent the day removing any and all non factory wiring, no change. I unplugged the mod on the left side, and no change. I...

Also, the turn signal light stay on even with the flash relay removed

I got in my 80 this morning turn on the headlights, and the left side flasher acted as a running light. It will not blink, even though the relay works. This is not happening on the right side at all. Just the left side of the truck. Anybody else run into this?

Gah! Go figure. Thanks for the help, it is appreciated! I’ll search and see if there’s an aftermarket equivalent, but I kinda doubt it?

I’ve done a few searches with no luck on this and I’m hoping someone has done this before. I’m going to replace my door cards with ABS, and would like to delete the wrap over leather like part of the door panel. Is there a model of 80 outside the US that dose not have this? And any guesses as to...

@alia176 no. Still factory much to my chagrin. I’ll eventually get an aluminum radiator, but it’ll still have the trans lines.

Thanks. Takes a load off my mind. I’m looking at a back surgery at the end of the month as well, but the front pinion is about toast, so that part really cannot wait.

I’m going to be installing a part time kit soon. The crux is this… I’m also regearing at the same time. I’d like to break the front gears in with the back as I tow off road and don’t want to put undo stress on the front without a proper break in. I also want to avoid tearing the front axle...

Great! And thanks. They are fairly close to me in the Bay Area!

Do you know if a specific company that refurbishes these? Thanks.