I am partial to the 2x4 tube. The only issue is you have to address the moisture that will drop from the B pillar, and if you have rust on the outside you probably have it on the back wall too. Mine was rusted where the floor supports turned 90...
Hey everyone, again apologies I am going to respond to all your messages, as of now I have the front floor pans and the supports for under them, I haven’t had time to talk with fab shop on the other parts hoping to by end of this week as I will...
@Paraglider - I didn't see your responses until now and it does sounds like you fully understand how difficult, and the commitment it takes to bring these rusty relics back to life. Your words are so true that when we pursue our passions it is...
No Reserve: 4.7L-Powered 1964 Toyota Land Cruiser FJ45 - https://bringatrailer.com/listing/1964-toyota-land-cruiser-fj45-6/
Not my vehicle, but it is a beauty!
The body was removed from the frame prior to being stripped, coated with DP90 primer...
That's Pat's Ford and his water cutting facility. Not sure who has the big 🥥🥥
Pat was the one that cut out my radius arm brackets. Lot of steel from his shop is on my pig.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.