Recent content by kelly saad

Had to order some hardware and make a couple small adjustments. I am planning to have everything built and ready to ship out the week of the 11th. Thanks to all of you for being so patient.

Gaps aren't adjusted, welds aren't ground. It is just basically sitting there. ITS NOT DONE! This slotted design from my perspective is a game changer.

Just worried it will be critiqued in its raw stage because it looks unfinished. Figured I would wait. Looks awesome though

I was able to use the test fit LX and return it this week. I have everything I need to complete the orders and ship them out. We are most likely heading up to Colorado on Tuesday for the week so this will happen when I return.

I am almost done building all the orders. I am fitting one tomorrow to make sure it all fits correctly but at this point there seem to be no corrections needed. I did a good job back in 2019 when I updated the file after fitting the prototype.

Everything is fitting nicely. Built one set of headlights and it’s looking fantastic. Will build all the others tomorrow. Was a good day.

Building the first one now.

The LX is in the shop. I will be working on everything this weekend and hopefully have it all done. Again, I’m just double checking everything and making sure it fits since this was the only one made so far, and it’s only a prototype. The new parts were all adjusted in the file after this...

I will pick up the LX on Friday and start everything on Saturday.

Still available time openings in 2026. PM if interested.

Still available time openings in 2026. PM if interested.

Still available time openings in 2026. PM if interested.

Cut the 3 tabs off and use double sided molding/emblem tape