This is absolutely awesome. I’m so appreciative, inspired, jealous, envious of all the effort and details you’ve put into this. I want to embark on a journey like this - maybe not spread over 10 years :).
I recently acquired a 1969 FJ40 from...
NLA is unobtainium. Make one is about the only option. 3D printing could work, then reinforce it with a layer of fiberglass or maybe a section of like 3in aluminium of sprinkler line.
It's surprising that as many times as I have seen this question asked, nobody has a " hot factory spec = xx mm cold" number from doing them hot, then measuring what that # is cold.
No, I am not volunteering, I no longer have a 2f.
It’s a trying time for that week…you’re hoping for a good outcome. You’re checking the site and direct contact emails and some folks are like…” I asked a question but never heard from the seller”… makes you nuts as you only have the greatest...
Wanted to finish the seat mounts for the driver side… After my battle with the clothes dryer the other day, the new one was delivered and needed a custom install for the dryer vent. This 1 hour job took me 5 hours to finish so I could only get...
Next time check the part numbers on the gaskets you use, lol.
It was probably tuned to run with the bad hg and now it's good. Just tune the carb again, lean drop test and whatnot.