An over-due clutch replacement. A seized pilot bearing got it underway. more issues uncovered. A worn transfer input shaft caused by the input gear. Cruiser Outfitters was able to supply a new custom input gear that is one piece. It replaces the...
It's been another month! I have finished all of the welding that needs to be done on the driverside of the vehicle. I'm so burnt out on it I'm not even going to grind anything down or make it look somewhat decent at the moment. I just want to get...
I can chime in a bit as I have owned a few 80's, 100's and now a 70.
-The biggest problem with maintaining a 70 series is replacement body parts. Interior and exterior. If you smash a fender or your front grille, its not as easy and coming on...
Welcome.
A. You can daily drive anything if you try hard enough. That said... Diesel Toyotas aren't the best short mile DDers around! Be sure to give her some long hard miles too. I daily either a HZJ77 or 73 depending on the current state of...
Finally added in the temp sender in the radiator hose and went for a test. Only got about 45 drive in it so not a real big heat sink.
93F today, running down the interstate at 65mph.
2350rpms
EGT 769
12psi
188 degree water temp.
I still have...
Another weekend, another few projects knocked off the list. New cambelt water pump rad hoses turbo coolant hoses thermostat etc. Modified and chucked some old drawers in the box. And also redid the deck with some new transply.
it's a lot. aiming to get a good start on timing, h2o pump, radiator, coolant hoses, and a/c system this weekend.
I've had a lot of help from @OlYellr and my son korbin, and my wife emjay. as in wouldn't have a fraction of this done over the...
making some progress over the last few weeks. lots and lots of electrical, side window removal and repair. I'll just post some pics, in no particular order.
modded coastal kit. tire carrier soon.
side windows out. window weld is the spawn of...
My kzj73 had a small but annoying rear main seal leak since the day that I bought it 2 years ago . Ordered a new seal and called the guys at Terrain Tamer US to upgrade the stock clutch to a HD clutch ! While in it I dropped a set of 4:1 gears in...
I've put about 6000kms on this trailer since my last update, from around Alberta, down through Montana, Idaho, and Utah. It has been absolutely flawless and has gone places I didn't think it would ever go.
Here are a few pics from various...
Got this as a backup part for my HZJ77 but going a different route now so I don't need to hang on to it. Brand new Toyota sunroof glass with the rubber gasket. The rubber gasket itself permanently glued onto the glass and is not sold...
Some useful heater hoses from Toyota:
99556-30500 is a 500 mm bulk length. You can get less or more by specifying the length you want in the last four digits of the part number.
87245-14500 is a 90 degree bend with about 100 mm of straight...
I was able to find it here: Original Custom【公式】オリジナルカスタムパーツ車用品専門店|SANO AUTO - https://www.sano-auto.com/original_custom.html (scroll down to "BJ Grill").
Looks great! I reached out to them via their contact form on their website about trying to...
I've gotten this combo out for a few trips in July already, mostly within a few hours of home.
I'm hoping to have my gullwing window before the end of the summer, but the duct tape tint is holding for now.
I drove over the Blue Ridge via Swift Run Gap to get license plates for the newest member of my little RHD fleet.
Could only go uphill at about 40-couple mph but it's good enough. EGT's did not get too high. Boost was off the scale.
Monument...