Pay extremely close attention to knock. If you hear it, back off the throttle immediately.
Do not ever advance the base Timing past 3 degrees BTDC. ALWAYS run premium fuel and buy pure gas whenever you can.
Mine is a 2-stage activation. Injection comes on when RPM is above 3,100 and boost pressure is over ~3.5 PSI. Gotta have both before it kicks in.
50/50 methanol and distilled water at 14 gallons per hour.
I run a 14 GPH, 45 degree stainless steel oil-fired boiler nozzle with a 90 PSI Flojet demand pump.
I've only had it for ~22 years so I can't comment on long-term operation.
Ever have one of those weekends? 🫤
Success, but not without a battle. There were several bolts that the cutoff wheel was used on. But it’s done and the frame is ready for blasting and paint.
Last weekend I started working on removing the steel bed floor. My initial plan was to lift the bed and cut the floor out of it in one piece. That wasn’t possible, so plan B was to disassemble the bed. That worked, it just took longer. It also...
Correct, it's a diversion door. You pull the knob upward to fuel the sub. Down for the main. The door does not completely block the main when the sub is selected. If using the sub you need to fill it first, then the main. If you fill the main...
While I really enjoyed (and am proud of) the many hard miles we put on Paul the 62 over the last couple weeks, I’ll admit that one of the first things I did upon getting home was bust out Norman the 40 and did all my errand driving in her. She...
Oh and THANK YOU, IH8MUD @woody for the platform to be able to make this happen and to reach a community of like-minded beings!
Here’s more pics, cause I can…
Lake Como
more Raffle Night
Group Photo Gathering
Moving them in…...
Red mountain Road with @cruiserdan, @TexasLandCruiser, @Nomadcruisers44, @RevISK
Lake Como!!
BIG BETTY with Nomad Cruisers
A little Red Mountain Road line up!
More Poughkeepsie
CruiseHer 2025!
Just lovely out there!
Squishy tires...