looking for throttle assembly for 2F engine from firewall to carb. Need standard aircleaner assembly. my ride is a 1976 FJ40. May also need a Aisen carb. Have a weber but want to return to stock.
Swapped the front knuckles for mini to do a disk conversion.
Using a new fj tie rod and relay rod, had the mini steering arms welded shut and redrilled to fit the fj tie rod ends.
When all is assembled I still have what appears to be huge toe out. Can't screw the tie rod ends in any more...
I saw an aluminum replacement dash panel that holds 2 large gauges ( Speed and Tach) and 4 small gauges, but now I can't find it on the web....... It was about 99 bucks and had an arched top. It also required a little "cutting" of the stock FJ 40 dashboard to get it to fit. Anyone seen this...
OK, this is where I am:
1975 FJ 40, frame off, converted both the front and back to disk, front is mini-truck conversion. Back is monte carlo caliphers.
? Rear caliper brake lines, what do I need. looks like a banjo fitting on disk side, 10MM on the hard line side, right?
?Front disk, this...
Anyone know what the tie rod taper is for 1975 FJ40?
Hopefully it is either 7.15 degrees or 9.56 degrees.
My problem is that I just had my Mini truck steering arms welded shut and re-bored/Tapered (front disk conversion). But they don't fit my new stock FJ 40 tie rod ends - too tight, the...
Somewhere I heard or read that a Ford Ranger Tank will fit where the traditional auxiliary tank would go in the back of the frame of an FJ-40. Anyone know if this is correct and if it is, what year Ranger?
After seeking advice on the best way to go disk brakes in the front I took the advice of those wiser than me and got myself a mini truck axle and did the conversion. Everything seems to be ok except for now I'm in a quandry as to what to use for a tie rod and steering rod. I have the Saginaw...