CardinalFJ60's latest activity

killing it!!!!!!!!! :cool:

I could get pics and measurements of that setup off a sequoia if that helps. I know...it's a long shot but if it helps... and I have my gamiviti rack and towers pretty dang low. I can measure in a day or two (traveling right now)

in my experience if you do one, the other dies like right away. prolly my weird experience, but as stated, its easy to just do them both, be done with it.

If you already bought a new slave, I’d recommend putting it on. It takes about 10 minutes to install, and you can even do it yourself. You will be kicking yourself down the road if that salvaged unit craps the bed in the middle of nowhere.

@AVL KZJ78 nailed it. That is the 'INLET AIR TEMPERATURE SENSOR', part# 89424-12010

The Cruiser Outfitters shop has been the usual busy, rocking out some neat vehicle projects. Lots of suspension, bumper, and winch installs. A bunch of transmission, t-case, and differential builds. And a BJ74 clutch and t-case overhaul for Mr...

you have PM

I'm pretty sure the PS door cylinder is from an entirely different toyota. like a different pattern - I wanna say it's like my 60 key.

Welcome! For the lock cylinders, any decent locksmith should be able to rekey your existing lock cylinders to work with your main key. Or you can order a fresh set. Likely the key is so worn you could start it with a flathead screwdriver.

I'm thinking the plastic bushing connector piece is gone/missing

On a selfish note, I'd like an FZJ75 pickup vehicle keychain. I dig them and helps me find the right keys if I have a picture of them on the keychain. :rofl: ;)

oh man....you said it....I love these 70 series!!!!

Hello, Welcome to the madness. Juan

there are many things I want to get to - as I'm a bit of a perfectionist. but the good news is it's the neato cool stuff, not the essentials. it runs great, AC works, starts every time, it stops, hauls stuff and I love it. Big thanks for the...

the Heater valve was broken off and the hoses plugged on either end, I was hopeful it was just the valve, but my gut told me something's up with the heater core. so....onto the heater valve replacement and see what happens. a very creative plug...

And I've been driving it and using it as intended.

I then looked at the cool snorkel. Awww yeah! I have one for my LX470 I need to install...but this has one! Or does it?? the Dorkel was just drilled into the fender with sheet metal screws.

more fun in progress pics....ok...not that fun, but pics. the wiring was quite corroded and dropped into the bowels of the body. what I thought was a 15min. fix was not. :-)

I started to poke about and fix other little things like the intrument bulbs and dash illumination, Cig lighter and replaced the interior light. easy stuff and good instant gratification.

first things first - a general once over and baseline of fluids and minor/simple repairs. After the basic fluid exchanges (diffs, oils, etc) it was on to the front end. wheel and knuckle bearings, TREs, Shocks and steering stabilizer...

Hello 70's series Mudders! I've been living in the 60 series threads for a long time but dabble in the 40 and 100 series world too. I'm finally in the 70 series club! I learned about LandCruiser Pickups like 30 years ago and instantly was my...

there's a little cir-clip or e-clip or something similar that slip around that shoulder. It might be in the bottom of your door.

How many shops have you encountered that witness-mark all the fasteners after they  torque them? Impacts are conspicuous by their absence.

Same specs as a 60/62.

We do that @ Cruiser Outfitters