The Clutch of my KZJ71 is hard & after some drive, the paddle does not come back & I have to pull it with my foot toe.
Replaced Master Cylinder & Actuator. No luck.
Also removed the Spring at Clutch Paddle but same problem.
Gear shifting is OK.
Rig has done 180000 Kms.
I own a KZJ71 SWB.
It has 31-10.5 R15 A/T tyres
Want to lift it.
Found suggestions on google that best cheap option is to replace the coil springs
with of KZJ78 LWB.
Has anyone done & what is their input
on its performance/stability.
Need opinion & advise.
Regards
Happy New Year
I am still searching the M/T ECU for 1KZTE.
Till then I have installed A/T ECU.
It is working fine with some minor issues of Engine RPM at idle speed.
Rest is OK
& for all
It can be used as a replacement till correct ECU is in hand
My ride ECU is dead.
It is 1KZTE M/T (Manual Transmission)
Nameplate data is
89661-60230
175800-1283 12V
Make DENSO.
Could not find it & have replaced with a 1KZTE A/T
Nameplate data is
89661-26170
175800-1335 12V
Make DENSO
Now the ride is OK with following issues
Engine IDLE...
@Oldblue
I have a timer set at 20 sec for the glow plug. It is working fine. Also ambient temp here is ~ 30 deg C. So it is not cold but in fact hot.
I showed my rig to a Engine Mechanic, he said that the valves are sticking & the head needs to be re-furbished.
The engine has run 150K & I...
My KZJ71 has 1KZTE.
The Engine starts but stops immediately. It does so 3-4 times then it starts & runs fine with no issue.
This is happening on cold start.
Help required.
Guys,
I have bought a used snorkel.
Safari Snorkel
Made by "Luxon's 4 WD Equipment" Australia
P/No: SS75 HS
I want to install it myself & need help.
Can someone confirm
"Will it fit in my Toyota KZJ71" as on safari snorkel website I am unable to find this P/No. Also E-mail them but no...