AussieHJCruza's latest activity

15B-T engine build 19 Water pump time. This is an AISIN unit with the smaller drive plate for the fixed fan (no fan clutch) which the BJ60 originally came with. I have a fan clutch (from the Mega Cruiser) and fan and the fan clutch-type water...

I'm amazed that you found everything you need. Your hard work and determination paid off. You are quite the parts detective.

A G25 turbo is going to be WAY too small. That is a 48mm compressor wheel and even Garrett only recommends it for 1.4-3.0L engines. It has been several years but I posted all of the compressor maps and where you would need to fall on the map to...

So what is your MPH goal? What valve springs do you have? Valve float is probably going to be way more of a speed limiter than anything else you are addressing. 100mph with a 31” tire and 4.11 gear, and 1:1 transmission gear is 4600rpm.

Worth significantly less than a 1HD-### typically

So 1HZ. Cheers

80 booster is a great upgrade. With a 13BT you WILL need a large vacuum reservoir.

Parabolics every day, hit up @orangefj45 and his crew for a quote.

Didn’t see that coming. Joking.. Glad it’s fixed!

Pre 95 1FZs have a single O2 sensor, 95+ don't. Most aftermarket exhausts have a bung welded on but no hole in the pipe so they can be used on both - just drill a hole and you should be sweet

Snap rings…. Or bearing material. Probably the latter. Drive it till it blows up. Or address it now.

Mobil Delvac is not the same as Delo, but it's a good oil for these old trucks. I even run it in my 1FZ

When man-a-fre was in Simi Valley, their machine shop and builder was Martin Davidson automotive in Reseda California. But since moving to Nevada I have no idea. When Martin was doing the rebuilds they were top-notch. I have one of his 2Fs in...

That would go straight back where it came from and get someone who gives a damn to build you an engine...

Damn. That paint is terrible.

First day - stripped out all non original wiring / alarm and immobiliser / cb radio / cruise control / LP gas system (just not the tanks yet) Managed to get it to run for a few seconds…

Done!

@Silveredition Posting "should I buy this Land Cruiser" on Mud is like walking into the pub and asking the old guys at the bar "should I have a drink??"

A sticky throttle cable can create low idle situations. The idle is controlled by the computer through the idle air control valve. This valve adjusts the amount of air that by- passes the throttle plate to maintain the idles RPM. With a...

Throttle cable doesn't set idle, the ECU does with the IAC. Have you had the intake hose off or disturbed recently?

Pics? Probably the front main/oil pump O-ring etc from Wits End? That used to come with a pipe cap to use as a seal driver