60 toy ota's latest activity

Yes, for the OEM phone controls like in the first post of this thread.

...and the white is ground and the green is the horn. I don't have the EWD in front of me, so I can't comment on the brown and red wires. But they're in there. I just went through this on a 2000 LX470.

That connects to the lower intake manifold on the side facing the firewall. it's a tight squeeze but doable. BTW that's oil level, not pressure.

Following up on this for future readers, it's the orange and grey on the far right.

Ouch! That sucks. Any submerged vehicle is an immediate write off in Aus. Salt water causes corrosion. Fresh/ flood water carries a lot of organic material, perfect for breeding mold and mildew. Mechanical stuff can be cleaned and dried and...

I'm nearing the end of this same project, I do have those wires but the colors between the clock spring and the main column connector are different colors and the ewd doesn't acknowledge that (the 2 are black and white beyond that connector)...

Well, I finally had her towed home last night. The stoke meter is pegged at 11. Let the head gasketing begin! *edit- The local dealership quoted me $2500 to do the HG, which is about $1500 less than all the indie shops I called. I'm going to...

That all goes out the door when you shut a warm engine off and your oil pressure goes to 0 immediately while the coolant drops off over several hours. Hoping your pressure test shows a good head gasket. I also was expecting the worst when you...