Recent content by 4bangr

bringing back an old thread... i just installed a new(to me) housing. I see I have horrible positive camber - \ / been reading up on it, and was thinking that if I'm using rear springs on the front, and have moved the spring perch forward, beyond center, moving up towards the front spring...

i have a '92 FJ80 i'd like to sell. just rebuilt front axle with seals/bearings/TRE's/shocks. 205k miles. some rust. i'd like to get $2k out of it. i'm in Pierre 605-six ten - 959one https://www.dropbox.com/s/neer133skgftq6i/fj80.JPG?dl=0

I took the bolt out and the foot thing is all that comes off. the kick panel looks like it's connected to the trim piece that goes all the way across the bottom of the door. there is no "screw thing" on the panel, in fact the panel would pull off except for the trim piece; which is the piece i...

so, new to 80's here. found a good thread on fixing my rear defroster and was going to remove the driver kick panel and so my question; do i just unsnap it with a screwdriver? I hate to break it, which I'm really good at. thanks for your help.

my new FJ80 new to FJ80's. '92 I doubt it's ever been in 4L, needs some tlc though.

sent you a PM

I added some 1/4" flat bar strap to the stock tank protector. I used to see it as a potential weak area, but got to say, I don't think I've ever so much as scratched it.

Advanced Adapters Ranger overdrive torque splitter for chevy drive train. I ran it in front of a SM465; great condition. I'd like to get $1k for it. location = Idaho I think this is the model... 760002M-27 | Engine & Transmission Conversion Adapters - Advance Adapters email me at...