6 full days since a WDYD post? I'll go.
Just DD this thing sans FRP while we still have sun.
half doors made a big difference in exhaust smells. Still get all the other outside smells but less my exhaust smells.
Been wanting to get this photo for a while...had to wait until the middle of the night for the parking lot to be empty. Wish I was a better photographer.
Used some tiny screws and hardware to secure the new interior vents and the duct register.
New vent, with my heater plumbed up to it.
Other side just got a new stock duct and exterior/interior louvers.
Nothing was really wrong with the duct...
Finally got around to installing my heat duct register. Drew it up in Solidworks and had a friend print it out.
I had bought a couple new interior vents a while back as mine were both broken. The P.O. had glued/epoxied the vents to the...
Digging through some old photos, you can see where I got the 4x4 interest…
I loved this bronco we had. This photo was around 1979 or 80. Check out those side pipes 😂
This was my dad’s toys pre-FJBen. Photo date says 1969. Ford Torino
Boring trip report…
I took the cruiser on another work trip. This was almost 4 hours one way. The trip started out fine. Awesome weather. I was really going to take the Jetta because it’s made for trips like this.
Some might consider...
Trying to determine the correct orientation of this clip.
Looks like it should face forward, but just wanted to ask before I sunk it home and have to break it to remove...
Parts diagram.
Been a while! Life's been busy, but last week I took my buddy Miguel out across Utah and Nevada into the Lost Sierra in the Troopcarrier. 2,600 miles round trip. Zero issues. Unless you could third gear, 45 mph up all those Basin and Range...
Here's more pix. thought that I'd posted these as well. I'd prefer selling the whole thing. Center section has been notched for pintle hitch clearance.
Thanks for feedback which prompted me to check on the US data
https://www.aluminum.org/sites/default/files/2021-11/FactSheet2018.pdf
As of 2018, US aluminum follows
30% is from US production
30% is imported
40% is from recycling ( => 30% + 40% =...
Cross post here, worth a shot. I need these gone.
https://forum.ih8mud.com/threads/boise-id-70-series-rear-bumper-side-steps-front-bumper-chrome.1367772/
New Take off Troopy body. 78 series
This is a body not a full vehicle!
Complete with all body panels.
Headlights, signal lights, grille, front bumper.
Rear bumper and tail lights
Factory roof rack still in the box.
Interior is complete with all...