I sanded nearly all the gelcoat off, gouges eachbcrack with a die grinder and filled with fiberglass. Sanded that down then Coates with gel coat. Let that cure the sanded it and uses 2K primer to fill minor imperfections. Was a TON of work.
Currently in Jacksonville Arkansas but heading to Crawfordville FL with the parts Saturday. Rather not ship but will with buyer paying.
1975 FJ40 drivers door complete with glass, regulator, latches, ect. Has rust on bottom.
Left and right ambulance doors, both have rust on bottom. Complete...
I'm just getting into the top repairs and the fiberglass is covered in spider cracks. I did some reading up and common repair is to take a Dremel to all the cracks then apply gel coat. There are so many cracks I think I am better of to sand all the gel coat off and apply new gel coat. Anyone...
Thank you for the replies and advice. I do have a wire diagram and it has helped. I check and replaced the fuse and cleaned the terminal. I have 12v+ on both sides of the fuse. It is the original harness and it has a SBC conversion from the 1980s. I had to clean up the harness from the...
I'm thinking that as well. So far I confirmed the ground using a miltimeter to check ohms and both are good at the bulb socket. I checked the connection at the column and the low beam (red/green wire) has 12v going into the connection but only 6.5 coming out. Going to keep checking all wires and...
I searched the forum and didn't see anything covering what I'm experiencing. Working on a rebuild of a 1975 FJ40. Did a frame off and am at the point of checking lights and systems. So far so good but headlights are being strange. I have power to both left and right headlights at the bulb. Both...
I was hoping I could have it repaired but when I went to the alternator amd starter shop he refered me to the Armature specialist. They checked it out and said it was beyond repair.
I need to replace my rear heater motor in my 1975 fj40. The one I have is not repairable per the local armature repair shop. Before I but a 40 year old used OEM I thought I would see if there is an aftermarket motor that might be an improvement over the original. I looked around a bit and don't...