I have owned about every Land Cruiser model except a LV. I have searched for one over the years however very few are available and even less in good condition.
In August 2023 I heard about one in California in which the owner has had for the...
Finally got off my wallet 🤣
These showed up available in my favorite size for a cruiser, so, ****it.
Not bad. 4 delivered was 1350 after rebate from PMC tire, and then a hundred bucks to get them mounted today.
So now to sell off this...
Saw some snow and wheeled around to some hot springs. Otherwise I had a buddy whip up some accelerator stop pins, good for 70-90 two barrel F/2F/3F carbs which has been great. Lastly….still looking for these brackets below if anyone has clean ones.
Still just doing my 70mi daily commute, truck is doing great. Took a small break and ran up to Spokane/Coeur d’Alene for a ve-pump motor. Decided to stop in Pendleton for a burger and a beer…one of my last decent burgers and beers until after...
Hi guys, just wanted to hop on here as we've seen lots of comments about the retirement to this day. Todd is still looking to retire but we're still in business as usual! Although he's ready to relax, we will continue manufacturing all parts for...
We have basically a brand new 1HZ engine with R151 trans and new school 79-series BF1B tcase. The 1HZ is a non-EGR model.
6220kms or 3,885 miles on it all, as you would expect it’s brand new.
Everything from fan to tcase output included...
Got an extra new H55f here, $2600 until the end of the month. I normally sell these for $2750. Can ship anywhere. I also stock all other additional parts to make this work in your vehicle, hardware, transfer cases, oiler cups etc
I cleaned up 3 1963-1968 5 terminal fuse blocks, original screws, and wire clips. The main frame was bead blasted then painted silver.
Correct fuses, and all tested ok.
They do not come with covers.
$50.00 each plus shipping.