Hi all,
I have just finished the install of a WTA intercooler in my '92 Surf, filled with water / coolant mix as best I could but EGTs are just the same as prior and it seems no heat is making it to the heat exchanger on the front of the truck. After a bit of mucking around including setting the truck up on an angle with one front wheel raised, I eventually managed to get a good flow of coolant through the radiator filler cap that's part of the system, but no result when I took the truck for a long test run. I opened the cap back up after giving it some time to cool down and it still looked full. I'm not getting any cooling it seems, so I figure there must be an air lock. Any tips on how to bleed would be much appreciated...
I have just finished the install of a WTA intercooler in my '92 Surf, filled with water / coolant mix as best I could but EGTs are just the same as prior and it seems no heat is making it to the heat exchanger on the front of the truck. After a bit of mucking around including setting the truck up on an angle with one front wheel raised, I eventually managed to get a good flow of coolant through the radiator filler cap that's part of the system, but no result when I took the truck for a long test run. I opened the cap back up after giving it some time to cool down and it still looked full. I'm not getting any cooling it seems, so I figure there must be an air lock. Any tips on how to bleed would be much appreciated...