WTB - Daystar body mounts kt04009bk
- Thread starter Stormer
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I think you may be better looking into a 4Crawler kit.
Have been hunting Daystar's for three or four months, to no avail.
Be careful with the eBay seller's, too. Many will list with a sufficient quantity, take the order and your money, then spend a month figuring out that they're NLA, even after direct questioning asking them up confirm availability BEFORE the sale.
Have been hunting Daystar's for three or four months, to no avail.
Be careful with the eBay seller's, too. Many will list with a sufficient quantity, take the order and your money, then spend a month figuring out that they're NLA, even after direct questioning asking them up confirm availability BEFORE the sale.
Did they give any indication of lead time?
have you put them on yet? gr8 7/16" bolts are a good substitute for the old body mount bolts. you will have fun with the rear ones!
what are you going to do about the rear body mount rubber covers that cover the opening in the frame/crossmember? mine were all shriveled, and did not survive the removal process. i have been thinking about fabbing an aluminum replacement.
Lambcrusher gave me a good idea for covers, conveyor belting. I had some laying around and it worked perfect. The body, at least on mine, is not flat back there and the belting conformed to the shape nice. I'll look for a picture. I used RTV to seal it up.
looks like a good idea, and should hold up for a decade or two. thanks for the tip. i was thinking about using 22 ga steel hammered to fit and using seam sealer.