what exactly is needed for a v8 SBC swap? (1 Viewer)

[caladin]

What exactly is needed for a basic v8 swap in an 82 fj60? at this point, I'm assuming to keep the existing trans.

Of the top of my head i can think of...

SBC motor, fully dressed
Adapter from the motor to trans
Clutch kit
Adapter motor mounts

What else?

Thanks,

E-

 

[onemanarmy]

You talking carb'd/TBI 350 or a vortec 5.3/6.0?

 

[kiley7483]

You talking carb'd/TBI 350 or a vortec 5.3/6.0?

I am putting 350 with factory trans the bell housing I have says it will hold up to 14 inch flywheel so what clutch and pressure plate do I need

 

[the gimpey one]

Large stack of $$$

 

[Seth S]

there is a good overview thread in this section

heres 1:

How to LS Swap a FJ60 or FJ62. Quick and dirty guide for regular folks wanting to do an engine swap in their driveway.

This thread looks like a lot, but you can totally do this. I have total faith in you! I've been meaning to do this for a while now. I havent really seen any how to guides or anything online and this one isnt going to be absurdly thorough or anything but will get you onto the right track. If i...

forum.ih8mud.com

and theres another one for doing the V8 swap for the least $$ but cant put my finger on it at the moment

 

[dbbowen]

man, for the work needed and cost, go 5.3 with modern fuel injection. its only a little more work and worth the effort if you can swing it

 

[Zjohnsonua]

No reason to go SBC unless you already have one. There are many reasons folks moved on to LS units. The electrical "headaches" have plug-in solutions from many vendors now.

 

[dbbowen]

No reason to go SBC unless you already have one. There are many reasons folks moved on to LS units. The electrical "headaches" have plug-in solutions from many vendors now.

for real. I wired mine up to drive in 6-7 hours. excluding cruise and AC