I recently found a box of parts and need some help indentifying misc. parts from the PO of my 40. I think some of them are to secure the jack under the seat, but I'm not sure. thanks!
what are these misc. parts?
- Thread starter CardinalFJ60
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Coolerman
SILVER Star
- Joined
- Jan 5, 2004
- Threads
- 143
- Messages
- 6,766
- Location
- Paint Lick, KY
- Website
- www.globalsoftware-inc.com
#1 is a tool clip. Mounts on the rear wheel well to hold the jack rods.
#3 is a clamp for the emergency brake cable. Fits under a bolt on the transmission.
#6 looks to be the brackets on the windshield the the hold down knob screws into.
#3 is a clamp for the emergency brake cable. Fits under a bolt on the transmission.
#6 looks to be the brackets on the windshield the the hold down knob screws into.
Last edited:
What coolerman pointed out, then,
#2 looks to be an interior heater hose clamp
#4 is a front seat pedestal
#2 looks to be an interior heater hose clamp
#4 is a front seat pedestal
5 is a clutch linkage/ass'y spring, 4/6 are seat pedestals, 1 is jack handle/tool holder, 2 heater hose clamp, 3 is ebarke clamp off top of tcase......
5
5 is a spring.
Actually it looks like a spring form inside the e-brake (there are two like it in there)
5 is a spring.
Actually it looks like a spring form inside the e-brake (there are two like it in there)
#6 is a pair of windshield knob brackets.
Hey!
I was looking for those!!!!
:d
I was looking for those!!!!
:d
- Thread starter
- #8
Awesome! thanks~!
Thanks Guys! (even you, 2Bad!
) Jim, are really looking for any of this stuff? Once I determine whether or not I need it...I'll try to remember to PM ya'.
thanks again!
Thanks Guys! (even you, 2Bad!
) Jim, are really looking for any of this stuff? Once I determine whether or not I need it...I'll try to remember to PM ya'.thanks again!
Come on folks....
#3 is not found under the body on the transfer case....
#3 attaches to the top-rear section of the 2F intake manifold and positions the molded hose that runs between the PCV valve and the center of the intake manifold below the carburetor. The molded hose routes along the rear of the air cleaner assembly and is secured to the air cleaner assembly by little reusable metal tabs.
#26 in the pic from S O R <---- this is a link
#3 is not found under the body on the transfer case....
#3 attaches to the top-rear section of the 2F intake manifold and positions the molded hose that runs between the PCV valve and the center of the intake manifold below the carburetor. The molded hose routes along the rear of the air cleaner assembly and is secured to the air cleaner assembly by little reusable metal tabs.
#26 in the pic from S O R <---- this is a link
- Thread starter
- #10
excellent! thanks!!!
Daay-ummm....nice call Poser!
Daay-ummm....nice call Poser!
Number one is half of a set.
