So I'm making a routine run to wally world today and when i get out of the drive way, i notice the ABS light is still on. FWIW, it comes on as it should when I push the CDL switch and goes away appropriately (up until now). Wally is only a few miles away so I pull into the parking lot and kill the engine. Steering wheel feels like it vibrating a bit. Get out and visually inspect the ABS sensors. I just did my rear axle maintenance about 3 weeks ago and I cleaned them in the process. I did the front axle service about 6 months ago and cleaned the fronts then. When I get back in the car it feels like the brake pedal is vibrating slightly as is the steering wheel. ABS light stays on for the ride home. Funny thing is the brakes actually feel BETTER this way. They were a little spongy even with new pads/rotors/bleeing. On the way home i find a nice secluded spot and slam on the brakes. Sure enough, multiple tires lock up so no ABS. In the garage, I pop the hood and I can hear and smell what I'm assuming is the ABS actuator assembly over the left fender well. It smells like it is burning. I disconnect the harness nearest the fender line and the motor stops. I plug it back in and it stays off. A quick crank of the car and the ABS light goes off as normal. I pump the brakes a few times and it feels back to "normal" and the light stays off. While the light was on I used my scangauge to look for codes and it couldn't find any.
this is new territory for me and i'm not sure where to start. any ideas? thanks.
this is new territory for me and i'm not sure where to start. any ideas? thanks.