Finishing up the fabbing end of it and am looking for advise on the two openings. The plate that attaches the old school Bellevue winch to the bumper and the opening for the fairlead.
This is what I understand and that is that the line must be straight across from the winch through the opening of the fairlead.
So how much of an opening do I need for the fairlead? The width of the roller opening is 3/4". Would you make it slightly bigger than that? How large of an opening for the winch plate?
Thanks,
This is what I understand and that is that the line must be straight across from the winch through the opening of the fairlead.
So how much of an opening do I need for the fairlead? The width of the roller opening is 3/4". Would you make it slightly bigger than that? How large of an opening for the winch plate?
Thanks,