Buy the winch anyway. That's a great price. I'd use it without hesitation on a 100 series. It may be rated at 8000 pounds, but I'd take it anyday over the 9500 that at lot of 100 guys are fond of. At that price, you should buy it as a favor to IH8MUD. You could sell it in a day at that price. Remember it is Warn's best product.
it probley wouldnt fit but they're right it is the most under rated winch I bet its more like a 10K on todays standards if you make it fit you'll love it its way fast
this is what i've always understood as well, but according to warn's site, at full load, it's their slowest winch in the sub-10,000# category. it's their fastest winch with no load but what does that matter?
this is what i've always understood as well, but according to warn's site, at full load, it's their slowest winch in the sub-10,000# category. it's their fastest winch with no load but what does that matter?
this is what i've always understood as well, but according to warn's site, at full load, it's their slowest winch in the sub-10,000# category. it's their fastest winch with no load but what does that matter?
Buy the winch anyway. That's a great price. I'd use it without hesitation on a 100 series. It may be rated at 8000 pounds, but I'd take it anyday over the 9500 that at lot of 100 guys are fond of. At that price, you should buy it as a favor to IH8MUD. You could sell it in a day at that price. Remember it is Warn's best product.
this is what i've always understood as well, but according to warn's site, at full load, it's their slowest winch in the sub-10,000# category. it's their fastest winch with no load but what does that matter?
all I know is I have had a mid 80's 8274, m8000, XD8000i, XD9000i and a M12000 the 8274 was the fasted puller hands down I miss it alot ... I hope the fell on the foot of the A$$ hat that stole it
I just took some measurments and kinda looked things over.
Comparing my 40m with an 8274 to my 100.
The frame rails on the 100 are about 30" compared to the 22" on the 40.
Any cross member you built would have to be trussed to distribute the stress or it would be likely to bend.
Also the motor and soleniod box would almost completly block air flow through the radiator, well at the least ristrict it. Probably wouldn't be a huge problem but worth thinking about.
