Turn signals do not work after replacing steering wheel (1 Viewer)

Joined
Sep 6, 2006
Messages
27
Location
Roswell, GA
 
 
I pulled my steering wheel to be rewrapped in new leather. Reinstalled in reverse order, all systems go, except the turn signals do not work. The hazard lights work fine. I believe the relay is the same for both based on FSM and a quick mud search. I was very careful (but not entirely successful) to not move the column while the wheel was out to ensure the point of alignment stayed put. I have attached a cropped pic of instructions when installing a steering wheel or turn switch assembly.

Any ideas....???
IMG_5829.jpg

Thanks,

jhowg8
 
Joined
Sep 6, 2006
Messages
27
Location
Roswell, GA
 
 
ID10T update - I have been waiting for a CLD switch and therefore had not reinstalled the face place which includes the harness/switch for the hazard lights. I decided to connect the switch in an a-ha moment ..... turn signals work.

The end.
 

Users Who Are Viewing This Thread (Users: 0, Guests: 1)

Top Bottom