Build The Short Rib

Member Builds and Stories

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I don't know the answer, but I love that you are asking it. Mine came with a funky 70s insert that i kept and I did something similar to the these on my first 40 years back. I know the originals are iconic, i've always found them clunky.

1782828768543.webp
1782828809809.webp
 
Summer is about to come to and end so I can get back to work on the 55. I picked up the bench seat from @pb4ugo in Ohio and got it home. Looking at my 55 and this seat has me scratching my head. I am now concerned I am missing a ton of hardware to mount this this thing.

IMG_0016.webp
 
Summer is about to come to and end so I can get back to work on the 55. I picked up the bench seat from @pb4ugo in Ohio and got it home. Looking at my 55 and this seat has me scratching my head. I am now concerned I am missing a ton of hardware to mount this this thing.

View attachment 4204231
There isn't a whole lot of hardware associated with the rear seat, a couple of pins, a couple of hinges and two latches.
Do you have any of that?
 
That is good as I found some pictures of brackets with cable releases? All I see on my 55 are the two front seat bottom brackets that accept the pins. I don’t see any other mounts on the chassis side. The seat back has some hinge type brackets and the latches on the side, it seems complete.

Here is a pic of the other side of the bench and one of the rig.

IMG_0017.webp

IMG_0018.webp
 
Gonna need those towers that the seat back latches onto...
 
@kbahus I have several sets of the bracket and catch for fenders for rear seat to latch to. Pins I’ll dig out for the bottom of rear seat, looks like your pig still has the mount on floor for rear seat hinge, only thing I won’t have is a cable and release for the bottom. two of those pigs are older and don’t have the catch the seat just folds down and is in place. the seat back looks like passenger side hinge is a little messed up on yours if you can’t get it to straighten out I’ll pull a hinge off one of the seats. I’ll get a box together of parts I can see you’ll need and then go from there.
 
You guys are amazing as always! Those tower brackets the sides latch to I certainly did not plan for. The roll bar looks like it mounts right where they go so I am going to have to figure out that obstacle before moving forward. I am guessing that is why those bucket seats were installed in the first place, it would have been simpler to move the roll cage mount somewhere else when the rig was built. My next option would be a PRP bench seat that I could attach to the current seat framework, I like the factory bench much more though.
 
Might be able to do some notches on the back side of the seat catch bracket and make it one with the roll bar. As long as you can get the seat to latch. On my wife’s I ended up adding a spacer to the latch off the fender bracket to make the back of the seat sit a little straighter up when I built out the back. Gained like 1/2 an inch in the back with how we built it out and the kids can’t notice that the seat sits more upright so
 
Back
Top Bottom