I was looking through my photos and came across this pic which reminded me of this tent I have for my M416. It's converted from one of those motorcycle pull behind units. You can see that the changing room area isn't long enough to reach the ground. I had intended to have a section sewn in in that area but after using it like you see it I decided against it.
I used some Action Packer boxes I had as a base for it and turned out liking it that way. It kept it off the ground, out of the wet and acted as a "step". Stepping from the ground to the sleeping area would be quite a feat, but step from the ground to the box, to the bed was much much easier.
Anyhow, to make a short story long, I don't need this any more and would be willing to unload it to whomever might be interested. It has a "base" that mounts to the lid of my trailer, which is nothing more than plywood that I covered in black vinyl. I put velcro all around the trailer lid to secure the tent sides to.
I would advise a potential buyer to forgo the base I made due to shipping issues and just make their own. I would be more than happy to provide help with measurements and such. Someone who could pick it up would be the best scenario.
With a little bit of DIY somebody could have a pretty spiffy tent setup for pretty cheap. Anybody interested should give me a shout at tgreening who is at neo dot rr dot com. I know you can figure that out.
Feel free to ask questions. A few pics...
I used some Action Packer boxes I had as a base for it and turned out liking it that way. It kept it off the ground, out of the wet and acted as a "step". Stepping from the ground to the sleeping area would be quite a feat, but step from the ground to the box, to the bed was much much easier.
Anyhow, to make a short story long, I don't need this any more and would be willing to unload it to whomever might be interested. It has a "base" that mounts to the lid of my trailer, which is nothing more than plywood that I covered in black vinyl. I put velcro all around the trailer lid to secure the tent sides to.
I would advise a potential buyer to forgo the base I made due to shipping issues and just make their own. I would be more than happy to provide help with measurements and such. Someone who could pick it up would be the best scenario.
With a little bit of DIY somebody could have a pretty spiffy tent setup for pretty cheap. Anybody interested should give me a shout at tgreening who is at neo dot rr dot com. I know you can figure that out.
Feel free to ask questions. A few pics...
