I have a 33x12.50 15 Super Swamper just sitting around and I also have a original steel wheel and was wondering if anyone knew if it would fit or if it is just too wide for the rim? Any info very appreciated.
Super Swamper 12.50 on stock steel wheel?
- Thread starter flippin sweet cruiser
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Not sure on the 33 12.50,
I have 33 10.50 on my factory steelies, I have to run them at around 28 psi in order to not ride the centers. These are bfg atkos though.
I have 33 10.50 on my factory steelies, I have to run them at around 28 psi in order to not ride the centers. These are bfg atkos though.
I have seen 38.5x11 boggers on a stock rim. They bulge out quite a bit but do fit. I've seen pics on this board of 33x13.50 bfg mt on stock rims. They bulge a lot.
In either case, airing down will be an issue. If you plan to use it as a spare, go for it.
In either case, airing down will be an issue. If you plan to use it as a spare, go for it.
- Thread starter
- #5
Yeah thanks guys. Its just going to be a spare just wasn't quite sure as the fitment goes. Thanks I will go ahead and use it on the steelie.
The hard part will be finding someone to mount it for you, Forget about balancing it. It will likely not work.
Dave
Dave
If you aren't worried about balancing, then mounting is as simple as a can of ether and a match 
.
.
