Talking to Superlift about their braided SS/kevlar lines. They don't offer anything specifically for 80s. Need to give them the length of the stock lines, tell them what OTHER oem lines have fittings/couplers that fit our rigs, and ideally supply photos of new or used lines off the vehicle. And then tell them the lift height so they can figure out what they have that works. I'll post whatever they come up with once they have the specs. I'm looking specifically for FZJ80 lines, but if I get the FJ80 specs, I'll find out about those too.
What I need, along with year and P/N if you have it:
What else fits--first-gen Tundra maybe? Not sure, but if so, then I can tell them the fittings are the same as first-gen Tundra fittings and that's half the battle.
Length of oem axle lines...
Left front
Right front
Rear
Length of caliper lines...
Left front
Right front
Left rear
Right rear
Pics would be nice.
I know most (all?) aftermarket lines have shorter couplers that require you to bend the stock brackets, or have fatter collars that mean you have to enlarge the mounting hole/find new c-clips, or do not allow indexing. Not sure whether any of that is an issue with Superlift, but let's find out...
What I need, along with year and P/N if you have it:
What else fits--first-gen Tundra maybe? Not sure, but if so, then I can tell them the fittings are the same as first-gen Tundra fittings and that's half the battle.
Length of oem axle lines...
Left front
Right front
Rear
Length of caliper lines...
Left front
Right front
Left rear
Right rear
Pics would be nice.
I know most (all?) aftermarket lines have shorter couplers that require you to bend the stock brackets, or have fatter collars that mean you have to enlarge the mounting hole/find new c-clips, or do not allow indexing. Not sure whether any of that is an issue with Superlift, but let's find out...
Last edited:
