CLC,
When I turn the key... nothing. Not even a click.
Here is the time line and what I have done so far:
Ignitor Died on the way home from GSMTR
Installed Pertronoix in place of Points & eliminated Ignitor
Drove it home from Forrest - Noticed it was not Charging - ran well
Checked Alternator - OK
Replaced Voltage Regulator - Now Charging
Jump started it and drove it to Sapaugh's - ran great - charged great
Hard to start leaving Sapaugh's - noticed starter cable loose
Tightened all connections - Would not start
New Coil
New Dist Cap & Rotor - both looked bad (burned) at cap to rotor connection
Battery checked OK - Full Charge
New Starter - Old one tested dead
Rechecked all connections and block to frame ground - looks OK
Ignition to ON......STILL NOTHING Not even a click.
Ideas?? TIA
I really want to get it running for this weekend!!!!!
Lash
When I turn the key... nothing. Not even a click.
Here is the time line and what I have done so far:
Ignitor Died on the way home from GSMTR
Installed Pertronoix in place of Points & eliminated Ignitor
Drove it home from Forrest - Noticed it was not Charging - ran well
Checked Alternator - OK
Replaced Voltage Regulator - Now Charging
Jump started it and drove it to Sapaugh's - ran great - charged great
Hard to start leaving Sapaugh's - noticed starter cable loose
Tightened all connections - Would not start
New Coil
New Dist Cap & Rotor - both looked bad (burned) at cap to rotor connection
Battery checked OK - Full Charge
New Starter - Old one tested dead
Rechecked all connections and block to frame ground - looks OK
Ignition to ON......STILL NOTHING Not even a click.
Ideas?? TIA
I really want to get it running for this weekend!!!!!
Lash