So I broke a bolt in my lower thermostat housing...

[fueg0]

And I need some recommendations on a machine shop. Any suggestions?

thanks,
--jeff

 

[krookedpandas]

Where are you located? I use south austin machine on south Lamar.

 

[fueg0]

I'm up in p-ville.

where at on South Lamar ?
--jeff

 

[krookedpandas]

Manchaca and Lamar, across from thundercloud.

 

[warpdriv]

There is a machine shop off of Sam Bass Road in RR. I do not know the name but after you cross the railroad track, there is a sharp right hand curve. In that curve turn left into the driveway and they are on the right. I used them to rebuild my output shafts on my tcase so the new seals would not leak.

Jason or Mark may know too.

 

[Michael Hanson]

Why dont you drill it out with a solid carbide drill bit? Mike

 

[fueg0]

I don't have a drill press, and I managed to break a bolt-extractor in the remains of the bolt.

--jeff